µDIGI2-E
µDIGI2-E
27
All information contained in this manual, unless indicated, is valid for both
µDIGI2-E
models.
µDIGI2-E
is universal digital indicator fully configurable that allow input type selection in order to be used as
needed. Available signal inputs are the following:
DC VOLTAGE
(±600V, ±200V and ±20V)
DC CURRENT
(±5A, ±1A, ±100mV and ±60mV)
AC VOLTAGE
(0-600V, 0-200V and 0-20V)
AC CURRENT
(0-5A, 0-1A, 0-100mV and 0-60mV)
The basic instrument consists of a soldered assembly composed of a main board, a display and an input signal
circuits. It can also be incorporated, as an option, an extra plug-in 2 SPDT 8A relays circuit output which is isolated
from signal input and power supply. This extra circuit has independent connectors that are located on the rear part
of the instrument once it is installed.
Specially designed for the industrial signals monitoring, both models have 4 digits, configurable decimal point and
2 LED’s for setpoints status indication, they are easy to scale into desired engineering units, directly by frontal keys
or rear input signal value in teach mode.
µDIGI2-E
is provided with
14mm-high
digits and maximum display range of -
9999
to
9999
.
The
µDIGI2-E
has three frontal keys to interact with internal software and set configuration in order to adapt
their function to particular applications. Device programming runs through some independent menus that show
short messages to easily identify input type and/or display configuration steps.
If relays output option card is installed, once it is recognised by the instrument, activates its own configuration
menu which is only visible under this conditions.
Device description
Dimensions and mounting
To install the instrument, prepare a
92x45mm panel cut-out and slide the unit
inwards making sure of placing the sealing
gasket between the front side panel and
the frontal bezel.
While holding the unit in place, put the
fixing clips on both sides of the case and
slide them through the guide tracks until
they reach the panel at the rear side.
Press slightly to fasten the clips to the latching slots
on the case and get the unit fully assembled and
close fitted to achieve a good sealing.
To remove the instrument from the panel, pull outwards the rear fixing
clips latching tabs until they are disengaged, then slide fixing clips back
over the case.
