Eneo VKC-1357, Инструкция по установке и эксплуатации

Страница: 59 / 80

59
4.3.2 Flush Mount
Quick installation guide
. Locate the mounting template at the installation position
and drill the ceiling or wall if needed.
. Open Dome bubble assembly by loosening Ring cover
fixing screws (m) (3x).
CAUTION
Extreme care should be taken NOT to scratch the
dome surfaces and to protect it from dirt or dust at
any time.
3. Place Dome base assembly on pre-drilled position and
fix it through Mount holes (4x) by using Mount screws
with O-rings.
4. Route the power/ video cable to the connecting place.
CAUTION
Care should be taken the cable is NOT to be damaged,
kinked or exposed in the hazardous area.
5. Adjust the camera direction with Y-tilt bracket (j), Z-tilt
bracket (k) and Pan bracket (l).
6. Adjust zoom by Zoom knob (i) and focus by turning IR LED
board (f) which is also used as the focus adjustor.
7. Put Dome bubble assembly over Dome camera assembly
and tighten Ring cover fixing screws (m) (3x) by using
L-shape star wrench
CAUTION
• Make sure that IR LEDs or Light sensor (e) are NOT
blocked by Shield dome (r) or Ring cover (o).
Day/night malfuctions if Light sensor (e) is
obstructed. See section 4.3.3 for the best alignment
of Shield dome (r).
• Tighten enough Ring cover fixing screws (m) (3x)
so that there should be NO gap between Lens hood
(g) and Clear bubble (n) to avoid the light inflow
from IR LEDs.
Ceiling or wall
Mount screws with
O rings
Dome base assembly
Dome bubble assembly
L-Wrench