40
41
Highlight the
Use NAT
box and press the
button to toggle
On
and
Off
.
NOTE: When using the NAT (Network Address Translation) device, refer to the NAT manufacturer’ instructions for the proper network settings.
Highlight the box beside
DVR Name
and press the
button to name the DVR to be registered on the DVRNS server. A virtual keyboard allows you to
enter the DVR name.
Selecting
Check
allows you to check whether or not the name you entered can be used.
NOTE: The DVR name you entered should be checked by selecting Check, otherwise the DVRNS changes will not be saved.
NOTE: When entering no name or a name already registered on the DVRNS server, an error message displays.
Highlighting
OK
and pressing the
button registers the DVR on the DVRNS server. Proper DVRNS settings will display the help desk information of the
DVRNS server in the box beside
Help Desk.
CAUTION: If you want to use the same DVR name registered on the DVRNS server after initializing the system using the factory reset, you need to
contact the DVRNS server manager. Please record and save the help desk information before factory reset.
CAUTION: The DVRNS registration will be limited to one DVRNS server. The DVR cannot be registered to multiple DVRNS servers.
Please contact your network administrator when you want to register the DVR to another DVRNS server.
Callback Center Setup Screen
The DVR can be set up to contact a computer running RAS (Remote Administration System) on a LAN when an event occurs. Also it can be set up to dial a
pager with a numeric message when an event occurs if you have a modem connected to the DVR.
Callback Center Setup by LAN connections
Callback Center (LAN) Setup screen
Highlight the box beside
IP Address
and enter the IP address of the computer you want contacted during an event.
Highlight the box beside
Retry
and enter the number of times you would like the DVR to try contacting the computer. You can select from 1 to 10 retries.
Highlight the box beside
E-mail notification
and press the
button to toggle between
On
and
Off
.
Highlight the box beside
SMTP Server IP
and enter the SMTP server IP address, obtained from your system administrator.
Highlight the box beside
E-mail recipient
and enter the recipient’s e-mail address. Use the virtual keyboard to enter the e-mail address.
Highlight the box beside
E-mail sender
and enter the sender’s e-mail address.
NOTE: The e-mail address must include the character „@” to be a valid address.
Highlight the box beside
Authentication
and press the
button to toggle between
On
and
Off
.
Highlight the box beside
ID
and enter the SMTP user ID. A virtual keyboard appears allowing you to enter the ID.
Highlight the box beside
Password
and enter the SMTP password. A virtual keyboard appears allowing you to enter the password.
NOTE: Authentication should be turned On and ID and Password should be entered when using the SMTP server requiring user authentication.