en
duro
®
AS1210 3
Ref: AS1210-UM-TKI-0412-Rev.A.
INTRODUCTION
Congratulations on choosing the en
duro
®
AS1210 battery charger. This product has been
produced according to very high standards and has undergone careful quality control
procedures.
The en
duro
®
AS1210 is member of the family of advanced car- and caravan accessories
manufactured by en
duro
®
. This en
duro
®
battery charger will increase your battery’s
performance and prolong its life.
Before proceeding with installation and starting to use the battery
charger, please read this manual very carefully and be aware of all the
safety instructions! Keep this manual with the battery charger for future
reference.
INTENDED USE
This charger is designed for charging a variety of 12V lead acid batteries widely used in
cars, such as normal lead acid, sealed lead acid, gel, AGM and deep cycle batteries
whose capacity ranges from 14Ah to 230Ah.
The specialized design of the device, which is so called “the 9 stages charging
characteristic”, permit the battery to be recharged to almost 100% capacity. It also
makes it possible to connect the charger to the battery permanently when the car or
battery is not in use. This keeps it always in perfect state without damaging it.
Furthermore, this device is controlled by a 12-bit AD microprocessor in it, which make it
more smart and reliable. Compared with normal battery charger, this device contains a
special function of rescuing dead battery, with which, a deep discharged battery can be
charged up again.
Full protections against wrong connection and short circuit ensure the charging operation
is very safe.
By the electronic switch embedded in the charger, the charger will act immediately when
a battery is connected to it and the AC is plugged in. This gives the user the opportunity
to build in the charger permanently in the vehicle and just start it by plugging in the AC
power cord.
SPECIFICATIONS
For 12V normal lead acid, sealed lead acid, gel, AGM and deep cycle batteries.
Type
en
duro
®
AS1210
Input voltage
230VAC 50/60HZ 135W max.
Input current
1.2A RMS max.
Back drain current
<5mA (when no 230V connection)
Charging voltage
14.4V±0,25V
Charging current
10.6A (RMS) 7A DC ±10%
Ripple
200mV max. 0.3A
Battery type
12V, 14Ah-230Ah
Against dust and proof water grade
IP65 – For indoor use only
Audible noise
< 50dB (test from 500mm distance)
Ambient Temperature
0°C to +40°C