E N D U R A P R O D U C T S > I N S T R U C T I O N S > A L L - A L U M I N U M Z - A C
™
F I E L D R E P L A C E M E N T I N S T R U C T I O N S
12
11. Stapling Door Bottom to Panel
(ZAI-AA to ZAC-AA)
Attach Door Bottom with
two 1/2" crown staples and 80 PSI of
air pressure
at ends between the rigid ramp and flex fins.
STAPLE ON SWEEP-
If using a staple-on door sweep, staple on both
sides approximately every 6
"
along the length of the door.
Proceed to step 12
a)
b)
c)
1/4" Crown Staple
1/2" Crown Staple
Incorrect Size Staple
Correct Size Staple
When stapling the Z-AC Door bottom to the panel, staples should
be inserted between the Rigid Ramp and Flex Fins. Staples should
be aimed away from the kerf slots in the bottom of the panel to
prevent cracking of the door bottom, or damage to the kerfs.
The insertion of staples at an angle or in the wrong location will
result in damage to the door bottom
Only 1/2
"
crown staples should be used to secure the door bottom to the
panel. The use of staples with a shorter crown such as crown 1/4
"
staples
will result in cracking and damage to the door bottom.
a)
Rigid
Ramp
Rigid
Ramp
Flex Fins
Staples
b)
Wrong staple
location
Wrong staple
location
Angled into
kerf
Use 80 PSI of air pressure to insert
staples. Endura suggest using an air
pressure regulator for best results.
Staple position Along the Length of Panel
6”
6”
6”
6”
6”
6”
1/4
"
1/2
"
PSI
Required Air Pressure
FOR SINGLE, SIDELITE, HINGED PATIO AND FRENCH DOOR UNITS
