Endress ESE 2300 i, Перевод оригинального руководства по эксплуатации, Страница: 48 / 60

49
Maintenance
Installing the spark
plug 1. Turn the checked spark plug clockwise by hand in the spark plug thread on
the engine.Fig. 8-5 Ensure that the spark plug is inserted without it tilting, so
that the thread is not damaged.
2. Tighten the spark plug using the spark plug wrench supplied.
3. Press the spark plug connector firmly onto the spark plug.
The spark plug has been serviced in an orderly manner.
The generator is ready to use.
8.6 Cleaning the spark screen
The spark screen prevents escaping of glowing exhaust particles and is lo-
cated right next to the exhaust outlet. It must be disassembled every 100
operating hours and cleaned. The spark screen must be replaced if it is
strongly soiled or damaged.
Proceed as follows to service the spark screen:
One has the re-
quired tool • a small slotted-head screwdriver
• Wire brush
Requirements:  The generator is switched off.
 The engine and particularly the exhaust system have cooled down.
Fig. 8-7 Spark screen
Servicing the spark
screen 1. Unfasten the six screws Fig. 8-7 - on the exhaust gas side.
2. Unfasten the six screws Fig. 8-7 - on the spark screen.
3. Remove the fastening clamp Fig. 8-7 - on the spark screen.
4. Unfasten the spark screen out of the exhaust gas outlet with the aid of a small
slotted-head screwdriver and pull it out completely.
The spark screen is removed.