Endress ESE 2300 i, Перевод оригинального руководства по эксплуатации, Страница: 31 / 60

32
Commissioning
Fig. 7-1 Starting the generator
Proceed as follows to start the generator manually directly from the device:
Requirements:  electrical safety has been checked (see Chapter 5 ).
 the fuel tank is sufficiently full.
 oil level is sufficient (fill with engine oil before initial use, see Chapter 8.3.1
and the engine operating and maintenance instructions).
 there is an adequate air supply and air removal.
 all power consuming equipment is disconnected or switched off.
1. Disconnect all loads from the output side
2. Put the ECOtronic switch into the "OFF" position.
3. Put the air-release valve on the tank cover into the "ON" position.
4. Put the multi-switch into the “START" position.
5. With one hand hold the generator by the carrying handle and pull on the ca-
ble grip with the other hand until you feel a resistance. Pull on the cable
grip strongly.
The engine starts.
6. Slowly put the multi-switch into the “RUN" position after the engine has
warmed up.
The engine has started.
NOTICE!
Do not apply load to the generator immediately after a cold start.
► Allow the generator engine to warm up for a few minutes before switching on
a load when the generator has not been operating for more than eight hours
(or for very low external temperatures).