Endress ESE 1104 DBG ES FS DIN, Руководство по эксплуатации

Страница: 37 / 88

Status at: January 2013 ESE 904 - 1304 DBG DIN
37
1. Pull on the manual choke
(Fig. 4-1-(1))
in the direction of
the arrow (all the way to the stop if the engine is cold,
correspondingly less if it is hot).
2. Turn the START-STOP switch to "START" position
(Fig.
4-2-(3))
until the engine starts.
The motor starts.
Only activate the starter briefly (max. 5-10 seconds). Never
start or run the engine with the battery disconnected.
3. Return the choke
(Fig. 4-1-(1))
to home position (against
the direction of the arrow).
The engine has started.
The electrical devices can be connected and/or hooked up
after a warming-up phase of about one minute.
WARNING!
Devices with a remote start device are fitted with an
automatic choke. You do not need to use the manual
choke (on the motor).
1. Covering hood
(Fig. 3-3-(13))
completely open.
2. Pull on the choke
(Fig. 4-1-(1))
(completely for a cold en-
gine / appropriately less for a warm engine) and hold
firmly.
3. For model ESE 1104 / 1304, the manual fuel pump (see
Fig. 4-3-(1))
must be actuated 3 times.
4. Turn the START-STOP switch to position "1"
(Fig. 4-2-(2))
.
5. Advance engine at the hand grip of the reversing starter.
Support oneself with one hand on the device grip in order to
simplify advancing the engine.
The motor starts.
6. Return the choke
(Fig. 4-1-(1))
to home position (against
the direction of the arrow).
The engine has started.
ELECTRICAL START
NOTE
HAND START
NOTE