Installation
Heating jacket for Promass A, E, H, I, M, S, P
8
Hauser
3.2.3
Orientation
3.3
Installing the heating jacket
3.3.1
Mounting kit
Note the following points:
• Screws, nuts, etc. are included in the scope of supply.
• Dimensions and required space Page 13 ff.
Promass M, I
Join the two half-shells of the heating jacket by nuts and bolts.
#
Warning!
With large nominal diameters, a support may be required due to the heavy weight of the sensor and
the heating jacket. Never use the feed and return pipes of the heating system to support the heating
jacket!
The weight data for the sensors are listed in the "Technical data" of the corresponding Operating
Instructions.
Promass A
Join the plate of the heating jacket on the sensor by nuts and bolts.
Promass E, H, S, P
Join the two plates of the heating jacket by nuts and bolts.
#
Warning!
With large nominal diameters, a support may be required due to the heavy weight of the sensor and
the heating jacket. Never use the feed and return pipes of the heating system to support the heating
jacket!
The weight data for the sensors are listed in the "Technical data" of the corresponding Operating
Instructions.
Vertical
Horizontal
Horizontal
Inclined
Inclined
Transmitter
at the side
at the top
at the
bottom
at the bottom
at the top
Sketch
a0004572
a0004576
a0004580
A0008136
A0008137
Recommendation
Recommended
Recommended
(
m
)
Recommended
(
n
,
o
)
Recommended
(
m
,
p
)
Recommended
(
n
,
o
,
q
)
T = Process connection heating jacket
m
This orientation is
not suitable
for fluids with entrained solids.
n
This orientation is
not suitable
for outgassing fluids.
o
This orientation is
not suitable
for low fluid temperatures.
p
Depending on medium temperatures.
q
Depending on heating medium.
T
T
T
D
T
T
E
T
T
