Heating jacket for Promass A, E, H, I, M, S, P
Safety instructions
Hauser
5
1.4
Return
The following procedures must be carried out before a flowmeter requiring repair, for example, is
returned to Hauser:
• Always enclose a duly completed "Declaration of contamination" form. Only then can End-
ress+Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per EN 91/
155/EEC.
• Remove all residues. Pay special attention to the grooves for seals and crevices which could con-
tain residues. This is particularly important if the substance is hazardous to health, e.g. flammable,
toxic, caustic, carcinogenic, etc.
!
Note!
You will find a preprinted "Declaration of contamination" form at the back of this manual.
#
Warning!
• Do not return a heating jacket if you are not absolutely certain that all traces of hazardous
substances have been removed, e.g. substances which have penetrated crevices or diffused
through plastic.
• Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be
charged to the owner operator.
1.5
Notes on safety conventions and icons
The heating jackets are designed to meet state-of-the-art safety requirements, have been tested, and
left the factory in a condition in which they are safe to operate. They can, however, be a source of
danger if used incorrectly or for use other than that designated.
Consequently, always pay particular attention to the safety instructions indicated in these Operating
Instructions by the following icons:
#
Warning!
"Warning" indicates an action or procedure which, if not performed correctly, can result in injury
or a safety hazard. Comply strictly with the instructions and proceed with care.
"
Caution!
"Caution" indicates an action or procedure which, if not performed correctly, can result in incorrect
operation or destruction of the device. Comply strictly with the instructions.
!
Note!
"Note" indicates an action or procedure which, if not performed correctly, can have an indirect
effect on operation or trigger an unexpected response on the part of the device.
