Endress+Hauser Proline 10, Краткое руководство по эксплуатации

Страница: 7 / 36

Flowmeter Proline 10 Modbus RS485 Safety instructions
Hauser 7
2.4 Adhesive labels, tags and engravings
‣
Pay attention to all the safety instructions and symbols on the device.
2.5 Environment and process
‣
Only use the device for the measurement of appropriate media.
‣
Keep within the device-specific pressure range and temperature range.
‣
Protect the device from corrosion and the influence of environmental factors.
2.6 Workplace safety
‣
Wear the required protective equipment according to national regulations.
‣
Do not ground the welding unit by means of the device.
‣
Wear protective gloves if working on and with the device with wet hands.
2.7 Installation
‣
Do not remove protective covers or protective caps on the process connections until just
before you install the sensor.
‣
Do not damage or remove the liner on the flange.
‣
Observe tightening torques.
2.8 Electrical connection
‣
Comply with national installation regulations and guidelines.
‣
Observe cable specifications and device specifications.
‣
Check the cable for damage.
‣
If using the device in hazardous areas, observe the "Safety Instructions" documentation.
‣
Provide (establish) potential equalization.
‣
Provide (establish) grounding.
2.9 Surface temperature
Media with elevated temperatures can cause the surfaces of the device to become hot. For this
reason, note the following:
‣
Mount suitable touch protection.
‣
Wear suitable protective gloves.
2.10 Commissioning
‣
Install the device only if it is in proper technical condition, free from errors and faults.
‣
Only put the device into operation once you have performed the post-installation check and
post-connection check.
2.11 Modifications to the device
‣
Only carry out modifications or repairs after consulting beforehand with an
Hauser service organization.
‣
Install spare parts and accessories according to the Installation Instructions.