Micropilot M
Hauser
15
3) Other possible values for the thickness are multiples of the values listed (i.e. E: 34 mm (1.34"),
51 mm (2.01"), …)
Antenna extension FAR 10
•
The antenna extension has to be selected
such that the horn extends below the nozzle.
•
If the horn diameter is greater than the
nominal width of the nozzle, the antenna
including the extension is mounted from
inside the vessel. The bolts are tightened
from outside, with the instrument lifted up.
The extension has to be selected such that
the instrument can be lifted by at least
100 mm (4”).
Special extensions
•
If the antenna has to be mounted on a
sloping or vertical vessel wall, an extension
with a 45° respectively 90° bend is available.
•
The smallest possible radius R for the bend
is 300 mm (12”).
Please contact Hauser for further
information.
Measurement from the outside through
plastic walls
•
Medium with dielectric constant
ε
r
> 10.
•
Maximum level 15 cm (6”) below tank ceiling.
•
Distance H greater than 100 mm (4”).
•
Preferred mounting by means of stand-offs
for adjustment of the ideal distance H.
•
If possible, avoid mounting location where
condensation or build-up might occur. In
case of outdoor mounting, the space
between antenna and vessel has to be
protected from the elements.
•
Optimum angle
β
between 15°…20°
•
Select vessel construction material with low
dielectric constant and corresponding
thickness. No conductive (black) plastics
(refer to table).
•
If possible, use an antenna DN250 / 10".
•
Do not mount any potential reflectors (i.e.
pipes) outside the tank in the signal beam.
Penetrated material
PE
PTFE
PP
Perspex
DK /
ε
r
2.3
2.1
2.3
3.1
Optimum thickness [mm / inch]
17.0
3)
/ 0.67
3)
18.0
3)
/ 0.71
3)
17.0
3)
/ 0.67
3)
14.4
3)
/ 0.57
3)
L00-F
M
R230x
x
-17-00-00-en-003
L
00-F
M
R230x
x
-1
7
-00-00-y
y
-004
L00-F
M
R230
x
x
-17-00-00-en
-0
05
www.aotewell.com
www.fa-market.com
AoteWell International.inc
Tel: +852-6563-2160
