Endress+Hauser Micropilot FMR20, Руководство по эксплуатации, Страница: 44 / 102

Repair Micropilot FMR20 HART
44 Hauser
12 Repair
12.1 General notes
12.1.1 Repair concept
The Hauser repair concept is devised in such a way that repairs can only be
carried out through device replacement.
12.1.2 Replacing a device
After the device has been replaced, the parameters can be uploaded to the device via
FieldCare/DeviceCare.
Condition: The configuration of the old device must have been saved using FieldCare /
DeviceCare.
You can continue measuring without performing a new calibration. Only interference echo
suppression may need to be carried out once again.
12.1.3 Return
The requirements for safe device return can vary depending on the device type and
national legislation.
1. Refer to the website for more information:
http://www.endress.com/support/return-material
2. Return the device if repairs or a factory calibration are required, or if the wrong
device was ordered or delivered.
12.1.4 Disposal
If required by the Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the product is marked with the depicted symbol in order to minimize the
disposal of WEEE as unsorted municipal waste. Do not dispose of products bearing this
marking as unsorted municipal waste. Instead, return them to Hauser for
disposal under the applicable conditions.