Endress+Hauser Liquisys M CPM223, Руководство по эксплуатации

Страница: 74 / 112

Commissioning Liquisys M CPM223/253
74 Hauser
6.5 Quick start-up
After power-up, you must make some settings to configure the most important functions of the
transmitter which are required for correct measurement. The following section gives an example of
this.
User input Setting range
(Factory settings,
bold) Display
1. Press the
F
key.
2. Enter the code 22 to edit the setup. Press
F
.
3. Press
S
until you get to the "Service" function group.
4. Press
F
to be able to make your settings.
5. In S1, select your language, e.g. "ENG" for English.
Press
F
to confirm.
ENG = English
GER = German
FRA = French
ITA = Italian
NEL = Dutch
ESP = Spanish
6. Press
P
simultaneously to exit the "Service" function
group.
7. Press
S
until you get to the "Setup 1" function
group.
8. Press
F
to be able to make your settings for "Setup
1".
9. In A1, select the desired mode of operation, e.g. "pH".
Press
F
to confirm.
pH
ORP (= redox) mV
ORP (= redox) %
10. In A2, select the type of connection for your sensor.
See the "Sensor connection" section for this.
Press
F
to confirm.
sym = symmetrical
asym = asymmetrical
11. In A3, enter the damping factor.
Measured value damping averages the individual
measured values and serves to stabilise the display and
the signal output. Enter "1" if no measured value
damping is required.
Press
F
to confirm.
1
1 ... 60
12. In A4, specify the type of sensor that you are using,
e.g. "Glass" for glass electrode.
Press
F
to confirm.
Glass
ISFET
13. In A5, select the temperature sensor the electrode
used has, e.g. "Pt 100" for a glass electrode.
Press
F
to confirm your entries.
The display returns to the initial display of the "Setup
1" function group.
Pt 100
Pt 1K
NTC 30K
None
S
SERVICE
S1
Language
ENG
A
SETUP 1
A1
Oper.Mode
pH
A2
Wiring
sym
A3
Damping
1
A4
Sensor
Glass
A5
Temp
Pt100