Enders URBAN, Инструкции по сборке и эксплуатации

Страница: 10 / 20

10
GB
REQUIRED TOOLS/AIDS
INSTALLATION SEQUENCE
The cap nuts have left-hand thread
1. Screw the cap nuts of the hose onto the screw
connection on the pressure regulator and tighten
the connection firmly using a wrench.
2. Screw the cap nuts on the pressure regulator onto
the screw connection on the gas canister. Tighten
the cap nuts firmly by hand. Do not use tools so that
the seal is not damaged.
3. Place the gas cylinder (5 kg or 11 kg) next to the
table.
4. Unscrew the protective cap off the screw connection
of the gas supply on the BARBECUE. Screw the cap
nuts at the end of the hose onto the gas supply on
the BARBECUE. Tighten the cap nuts firmly using
a wrench. Here a second wrench should also be
held against the designated area of the pressure
regulator.
5. Spray all sealing points with conventional leak
detection spray or apply soapy water with a brush
(ratio 1 part soap/3 parts water). Open the valve
on the gas canister. Bubbles appear at any leaking
points.
If a safety pressure regulator and a hose rupture guard
are enclosed for commercial use, please observe the
separate assembly/operating instructions for these
parts.
!
!
SAFETY INSTRUCTIONS
RISK OF FIRE AND EXPLOSION
Q
The BARBECUE may only be used with a pressure
regulator. The pressure regulator included is
correctly set by the manufacturer for use with liquid
gas. Please read and observe the enclosed separate
assembly and application instructions for the
pressure regulator.
Q
The gas barbecue, hose and pressure regulator
has only been approved for certain countries. (See
TECHNICAL DATA chapter or the ID label on the gas
barbecue under EC countries.)
Q
The gas hose must be replaced when the validity of the
tubing requires.
Q
The gas hose and pressure regulator must be replaced
periodically. (See CLEANING/MAINTENANCE chap-
ter.)
Q
Get advice from a specialist store when you buy or
rent the gas canister.
Q
Make sure that there are no sources of ignition, such
as open fires, in the vicinity when you connect or
replace the gas canister.
Q
Make sure that the gas hose is not kinked or worn.
Q
After assembling the gas canister, check that all
connection points are sealed using either a standard
leak locating spray or soapy water. If no leaks are
present, clean the terminals after testing them with
water.
Q
Checking the sealants using a naked flame is strictly
forbidden!
CONNECTING THE GAS CANISTER/CARTRIDGE