Encore E 3, Руководство по установке

Страница: 9 / 13

E3 IN REV. A 9
2. Push the Valet switch
3 times
(holding in on the
3rd push
) until one long chirp is heard, then release the valet
switch. You are now in the Alarm feature
“A”
programming mode.
3. Press and release the transmitter button corresponding to the feature you want to program.
a. The siren chirps and LED pause will indicate previously setting.
b. The factory default settings is always [1] LED flash, [1] chirp.
4 Depress the transmitter button to change the feature. Simple keep re-depressing the transmitter button until the
system advances to your desired setting.
Press the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulses
Three Chirps /
LED three pulses
Four Chirps /
LED four pulses
1
Active arming
Passive arming
without passive
door locking Passive arming
with passive door
locking.
2
Automatic Rearm
off
Automatic
Rearm on
3
Instant Door Ajar
error chirp
45 seconds
delay Door Ajar
error chirp.
4
All Confirmation
chirps on
Siren
Confirmation
chirp on only Horn
Confirmation
chirp on only
All Confirmation
chirps off
5 +
white wire =
Dome light
output
white wire = 4
th
channel pulse
white wire =4
th
channel latched
6 +
Lock/Arm &
Unlock/Disarm
Confirmation
Chirps
Lock/Arm
Confirmation
Chirp Only
7 +
ALARM with
Keyless Entry
Keyless Entry
ONLY
8 +
Car Jacking
feature Off
Car Jacking
feature On
Exit:
Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
45 seconds Delay Door Ajar Error Chirp:
This feature controls the error chirp that is generated if the system is armed with the door trigger active. This is useful
in a vehicle that has a long dome light delay after the door has been closed. If the system is armed before the dome
light has turned off, the security system will generate the door trigger error chirp. Use this feature to disable the door
open error chirp.
With Dome light turns on after ignition off:
Some vehicles turn on the dome light when ignition key is turned off. After remote start, with alarm on, a false alarm
may occur when the run time elapses and the dome light comes on. To prevent this from happing, program Alarm
Feature
A-8
to “With Dome light turns on after ignition off (45 second door by-pass)”.
ALARM FEATURE “B” PROGRAMMING:
1 Turn the Ignition switch
‘ON/OFF’ 3 TIMES
and stay in
OFF position
.
2 Push the Valet switch
4 times
(holding in on the
4
th
push
) until one long chirp is heard then release the valet
switch. You are now in the Alarm feature
“B”
programming mode.
3
Press and release the transmitter button corresponding to the feature you want to program.