ENCON SHOWER SHELTER Скачать руководство пользователя страница 4

Страница: 4 / 10

Doc. No: 01999929

Revision: C

4 of 10

Issue Date: 08/15/21

3. After adjusting each instance of ITEM 4 to assure bolt insertion clearance, tighten hex head set screws on ITEM 1

and ITEM 3.

SEE FIGURE 5 & 6.

4. Place ITEM 2 on the top of ITEM 9(used in step 1 and/or 2) and push the tee fitting in place assuring that the fitting

is firmly seated on the vertical support pipe. Lock in place by tightening hex set screw.

SEE FIGURE 7.

Repeat for

other side.

FIGURE 7

5. Insert ITEM 10 into ITEM 2(used in step 4) and place other end of ITEM 10 into the other ITEM 2(used in step 4).

Tighten hex screws.

SEE FIGURE 8.

6. Insert another ITEM 10 into ITEM 3(used in step 1) and place other end of ITEM 10 into ITEM 1(used in step 2)

Tighten hex screws.

SEE FIGURE 8.

7. Repeat steps 1-6 to assemble second side of shower shelter structure.

FIGURE 8 (Right Side Constructed illustrating all structural component parts)

Содержание SHOWER SHELTER

Страница 5: ...erting 2 ITEM 11 s between the ITEM 2 s at the top and by inserting 1 ITEM 11 between the ITEM 3 s at the bottom Tighten hex screws SEE FIGURE 9 FIGURE 9 2 Raise structure and locate near the shower equipment If required remove the ITEM 11 located on the bottom to allow the structure to be placed around the shower equipment reconnect ITEM 11 afterwards ...

Страница 7: ...teps 1 2 of panel assembly instructions assuring that the panel is centered prior to attachment of clamps SEE FIGURES 10 11 4 Repeat Steps 1 2 for the right side panel SEE FIGURES 10 11 5 Attach all remaining side and rear panel clamps flat side towards the panel SEE FIGURE 12 FIGURE 12 ...

Страница 8: ... of ITEMS 10 11 SEE FIGURE 14 2 Place ITEM 14 over structure and fasten clamps to roof as in STEP 2 of PART IV Note Do not tighten until all clamps are in place with nuts on screws SEE FIGURE S 13 14 3 Tighten ITEM 8 on all roof clamps SEE FIGURE 14 4 Remove UV decals from the panels FIGURE 13 ITEM 4 Roof FIGURE 14 Roof Rear Side Panels Assembled ...

Страница 9: ...es such that sufficient room for bolt placement is available 2 Mark bolt holes on pad and install anchor bolts supplied by others washer and lock nuts after placing structure over foundation SEE FIGURE 15 3 Inspect finished product for tight clamps joints and panels SEE FIGURE 16 FIGURE 15 FIGURE 16 Finished Shower Shelter Assembly ...