ENCO Control
Technical description
•
Kulautuvos g. 45a , LT-47190 Kaunas
•
Tel. (+370 37) 360234
•
Faks. (+370 37) 360358
•
•
www.axis.lt
15
There is possibility to setup parameters, download archive files, and update the software
remotely.
The selected system messages are sent to the user remotely:
- Power supply Off / On;
- Changing of Software (updating);
- Changing of the state of the logic inputs (high / low level);
T
he device should be mounted in the cabinet on a DIN rail, in horizontal position. Protection
class of cabinet must be IP65 (Figure 20, Figure 21).
The necessary switches must be provided during the installation (distance between switches
contacts must be
= 3 mm.)
With which you can turn off the power supply.
It is recommended to
establish the device in the same cabinet as the switches for cutting off power supply. The
switches should be adjusted for the power used by the equipment (max. 15VA).
Connection cables must comply with IEC 60227 or IEC 60245 standards. Cross-section of
cable is calculated by the allowable continuous current load.
Caution: If this equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
Fig. 11. Device Enco Control general view
Fig. 12. Device Enco Control. Top view
