BlueGuard VK Operating Instructions
3
Document no. 10100304
Specif
Specif
Specif
Specifications
ications
ications
ications
RADIO
BLUETOOTH, Class 2 (up to 10 meter, 33ft. range)
INDICATORS
Blue status LED
CONTROLS
Secure, magnetic switch requires magnet placement in correct location to activate
programming mode for changing the PIN (user programmable 4-6 digit PIN)
USER CAPACITY
Unlimited users (requires correct PIN entry)
INPUTS
ARM input, allows activation only when activated (unconnected if not used)
Connect ARM to ARM common to disarm BlueGuard output
Disconnect ARM to ARM common to arm BlueGuard output
OUTPUT
5 second pulse
Form C relay contacts (normally open, common, normally closed)
Contacts: 2A@ 30VDC, 0.5A @ 120VAC
CONNECTIONS
Power (2 wires)
Relay normally closed contact
Relay common
Relay normally open contact
ARM input
ARM common
POWER
12…30 VDC and 24 VAC @ 40mA (reverse polarity protected)
OPERATING TEMPERATURE
-40°C…82°C (-40°F…180°F)
0…95% relative humidity
HOUSING
Sealed, PVC
DIMENSIONS (dia. x height)
1” x 7.5” (25mm x 190mm)
WEIGHT
0.15lbs (68g)
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
The BlueGuard housing is durable PVC, watertight and designed for outdoor or indoor use. Bluetooth
devices have a
specified range of 33ft. (10 meters) in open air. This range may be reduced by obstructions. It is recommended that
BlueGuard be mounted in a secure location that is not easily accessed to prevent tampering or damage.
Outdoor Location
Outdoor Location
Outdoor Location
Outdoor Location
The BlueGuard housing provides a ½” NPT fitting to allow mounting directly onto the top of a gate operator and a
½” elbow is supplied for side mounting. BlueGuard must be mounted in the vertical orientation for optimum
range.
1. Chose a location for mounting and verify that there are no obstructions in the operator.
2. Make a clearance hole and mount the BlueGuard using the locknuts provided.
3. The joint must be sealed to prevent water from entering the operator. A good quality, outdoor silicone
sealant may be used.
Indoor Location
Indoor Location
Indoor Location
Indoor Location
Connections
Connections
Connections
Connections
The 4ft. cable provides connections to the operator for power, output and control signals. If additional length is
needed, use the remote gang box accessory available separately from EMX.
POWER
Verify that the available power supply is within BlueGuard’s supply requirements.
OUTPUT CONTACTS
BlueGuard’s output consists of a set of form C contacts. The common contact is common to both the normally
open (NO) and normally closed (NC) contacts. The NO contact will close when an authorized phone comes
into range while the NC contact will open.
ARM INPUT
The ARM input may be used to disable BlueGuard operation during certain conditions by connecting the ARM
input to a timer, occupancy sensor or any type of a switching device.
