7-22 Chapter 7
Expert Call Configuration
1)
If Circuit Type is Switched Virtual Circuit, press <Enter> to view or
modify the Expert Call Configuration parameters.
Figure 8-9 X.25 Expert Call Configuration
The X.25 Expert Call Configuration window is displayed. The
parameters in this window are applicable only to SVC’s.
The
Call Destination Name
field is a read-only field displaying the
name of the WAN Call Destination entered in Step 4.
2)
In the Request Reverse Charging field, accept the default value No, or
press <Enter> to change it.
3)
In the Fast Select field, accept the default value,
No
, or press <Enter> to
change it.
4)
If Fast Select has been enabled, the With Restriction field can be
selected. Accept the default value,
No
, or, press <Enter> to change it.
5)
In the Call User Data field, accept the default value,
None
, or press
<Enter> to change it.
6)
In the Generic CCITT Facilities Entry field, accept the default value, or
press <Enter> to change it.
7)
In the Generic National Facilities field, accept the default value, or press
<Enter> to change it.
8)
In the Suppress Calling DTE Address field, accept the default value, or
press <Enter> to change it.
9)
When you have completed all changes to the X.25 Expert Call
Configuration parameters, press <Esc> to return to the X.25 Call
Destination Configuration window.
Содержание DCP_link
