5
Unpacking
Your packing box should contain the following items:
•
The X
TREME
RGB-SDI2
If there are any discrepancies, you should contact EMS immediately.
Note:
All plug-in cards are static sensitive and are packed in anti-static material. Please keep the card
in its packaging until you are ready to install.
It is recommended that you do not discard the packing box until you are completely satisfied
with the X
TREME
RGB-SDI2
CAPTURE
card and it is fully installed and working correctly. We also
recommend that you make a note of the serial number of the card in a prominent place before
the card is plugged into the computer. This should hasten any query should you need to
contact our Technical Support Department. The serial number is displayed on the card itself
and the box label.
Installing the Capture Card
You are likely to need a flat blade and a Phillips head screwdriver for the installation of the capture
card; it
would be useful to have these to hand before you begin.
Installing the card is a simple process, follow the steps below to be up and running in a few minutes:
•
Power down the PC (including peripherals), switch off at the mains and disconnect all the cables
connected to the computer, noting the positions for accurate reconnection. Remove the PC cover
•
Locate a vacant PCIe (x4 or above) slot for the X
TREME
RGB-SDI2 on the motherboard and remove
the backing plate (retain all screws)
If in doubt consult your motherboard documentation to correctly identify a
PCIe (PCI-express) slot. If the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged
when the system is powered up and the warranty will be void.
•
Remove the card from its packaging and secure it firmly into the empty PCIe slot.
Extreme
care should be taken when securing the card into the slot as some motherboards
may have components that impede the siting of the card
•
Screw the card bracket to the back panel of the PC and replace the cover
•
Re-connect all cables to the PC
•
Connect the cable(s) distributing the signals to the connectors on the X
TREME
RGB-SDI2 card located
on the back panel.
•
Power up the PC and commence the software installation.
