Empire Comfort Systems VFLL38FP, Инструкция по установке и руководство пользователя, Страница: 9 / 48

32707-8-0714 Page 9
FRAMING & MOUNTING BRACKET INSTALLATION
NOTE: You must use the framing and middle mounting brack-
ets that are supplied with the fireplace. The brackets are
shipped under the burner cover, inside the fireplace.
1. Locate the three steel middle mounting brackets under the
burner cover. See Figure 2.
Figure 2
3. The brackets have a perforation located on each end. Bend
them at the perforation. See Figure 3.
Figure 3
4. Secure the brackets to the fireplace top with four screws as
shown in Figure 4. The screws are located in the hardware
packet inside the envelope pack. There are holes located in
the top of the fireplace for each mounting bracket. The hole
closer to the edge of the fireplace is for mounting noncombus -
tible board around the opening. The other hole is for mounting
the non-combustible board to the fireplace face (top, side and
bottom). See Figures 4 and 6.
Figure 4
5. On the top and bottom of each side are side framing stand-
offs. Use pliers to bend the side framing standoff 90 degrees
away from the cabinet. See Figure 7.
6. Locate framing brackets in the envelope pack. The holes in
the framing brackets allow different size boards and different
locations for the boards. See Figure 5. Bend the brackets
at 90° angles. Install four framing brackets with two 10 x 1/2
screws (each). See Figures 7 and 8. Use the front set of
holes if mounting around fireplace window. Use the back set
of holes if mounting around the fireplace face (top, sides and
bottom). Note: The non-combustible board provided is 1/2"
thick.
Figure 5
Figure 6
Figure 7
Figure 8
Note: Additional screws made be used with the side framing
brackets to give additional support.