Empire Comfort Systems VFLL38FP, Инструкция по установке и руководство пользователя

Страница: 33 / 48

32707-8-0714 Page 33
PROFLAME - IP CONTROL SYSTEM
OPERATING PROCEDURE
Initializing the System for the first time
Install the 4 AA batteries into the receiver battery bay. Note the
polarity of battery and insert into the battery bay as indicated on
the Battery cover (+/-). Place the 3 position slider switch in the
“Remote” position.
Using the end of a paper clip, or other similar object, insert the end
of the paper clip into the hole marked “PRG” on the Receiver front
cover. The Receiver will “beep” three (3) times to indicate that it
is ready to synchronize with a Transmitter. Install the 3 AAA type
batteries in the Transmitter battery bay, located on the base of the
Transmitter. With the batteries already installed in the Transmitter,
push the On button. The Receiver will “beep” four times to indicate
the Transmitter’s command is accepted and sets to the particular
code of that Transmitter. The system is now initialized.
Temperature indication Display
With the system in the “OFF” position, press the Thermostat Key
and the Mode Key at the same time. Look at the LCD screen on
the Transmitter to verify that a C or F is visible to the right of the
Room Temperature display. (Figures 53 and 54)
Figure 53 - Fahrenheit
Figure 54 - Celsius
Turn on the Appliance
Press the ON/OFF Key on the Transmitter. The Transmitter dis-
play will show all active Icons on the screen. At the same time
the Receiver connects the thermopile to the gas valve millivolt coil
and the appliance main burner turns on. A single “beep” from the
Receiver will confirm reception of the command.
Turn off the Appliance
Press the ON/OFF Key on the Transmitter. The Transmitter LCD
display will only show the room temperature and Icon
(Figure 55).
At the same time the Receiver disconnects the thermopile from the
gas valve millivolt coil and the appliance burner turns off. A single
“beep” from the Receiver confirms reception of the command.
Figure 55