Page 28
VFH-33
Wiring
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with
the National Electrical Code ANSI/NFPA No. 70, if an external
electrical source is utilized. This appliance is equipped with a
three-prong [grounding] plug for your protection against
shock hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove the
grounding prong from this plug. For an ungrounded receptacle,
an adapter, which has two prongs and a wire for grounding, can be
purchased, plugged into the ungrounded receptacle and its wire
connected to the receptacle mounting screw. With this wire
completing the ground, the appliance cord plug can be plugged
into the adapter and be electrically grounded.
CAUTION: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.
Oiling Blower Motor
The blower motor does not have oiling holes. Do not attempt to
oil the blower motor.
WARNING:
Unplugging of blower accessory will not stop the heater
from cycling. To turn off gas to the unvented heater: Push
in gas control knob slightly and turn clockwise to “OFF.”
Do not force.
PARTS LIST FOR EFB-2, BLOWER KIT
Index
Part
No.
Number
Description
1
R-2804-B
Blower Assembly
2
R-1498
Tinnerman Clip (4 Required)
3
EL-041
Blower Mounting Plate
4
R-1499
Rubber Grommet (4 Required)
5
R-1454
Brass Bushing (4 Required)
6
R-1404
Bushing 7/8" Diameter
7
R-896
Bushing 1/2" Diameter
8
EL-042
Switch Bracket
9
R-2807
Fan Control
10
R-1468
Strain Relief Bushing
11
R-2099
Cord Set
12
R-2806
Wire Harness
13
DVF-175
Switch Bracket - Blower
14
R-2805
ON/OFF/AUTO Switch
OPTIONAL BLOWER INSTALLATION INSTRUCTIONS (continued)
