32319-0-0713
Page 1
INSTALLATION INSTRUCTIONS
PVSWS1-1 WALL MOUNT SHROUD KIT
FOR USE ON: PVS(18,35)(N,P)-1
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
Tools Needed:
5/16” Nut Driver 10”+ Extension
Masking or Painter’s Tape
Phillips Screwdriver
Carton Contents:
Part Number
Description
Qty
32328
Wall Mount Shroud
1
WARNING
Due to the weight of the wall furnace the wall mount shroud
MUST be anchored into the wall studs. DO NOT use wall panel
anchors, the wall furnace may fall causing damage and possible
harm.
NOTE:
-
ration, install the pipe stop bracket and inlet pipe gasket sup-
plied with the air pipe kit prior to securing the wall mount shroud
to the wall.
3. Mark corners of shroud with masking or painter’s tape. Mark
Figure 2
!
" "#$ %-
ing screws are as close to the four corners of the shroud
as possible.
EMPIRE
EMPIRE
Comfort Systems
Installation
& '% "
mount the wall furnace.
Note:
Make sure that the height is appropriate to allow com-
fortable utilization of the display on the top of the wall
furnace. Maintain 12” minimum clearance from top of
Note for Garage Installations: The wall furnace must be raised
&(&)*%&4*%%%
required.
2. Locate the wall studs and move the wall mount shroud into
; <
not aligned with a wall stud. Make sure shroud is level. See
&
NOTE:
To help align the shroud mounting holes to the wall
studs, the holes, across the top of the shroud correspond to
the mounting holes on the back of the shroud. The shroud has
many holes and can be mounted on 16” or 24” on center studs.
Figure 1