Attach to your desk
(Mounting to edge of desk)
Attach to your desk
(mounting to desk cable opening)
Have you got everything?
Unpack the box (be gentle) and make sure all of these items are there:
Attach the bracket clamp to the base with the 3 cap
screws. Use the 4mm hex key to tighten.
Loosen the two screws that connect the two parts of
the clamp.
Adhere the bracket cover and the bracket clamp
cover to the support block of the bracket clamp.
Put the arm through the hole in your table.
Tighten the securing bracket by turning the
adjuster clockwise and make sure it’s tight.
If your desk is too thick, adjust the clamp
down a notch and re-tighten.
Install the lower part of the
clamp with the two screws.
Tighten the clamp until it is
securely fastened to the desk.
Nearly done!
Just a bit more
on the other side
of this page...
A. Gas Spring Monitor
Bracket with USB ports
B. Bracket Clamp
C. M4 x 8mm Screws (4)
D. M4 x 12mm Screws (4)
E. Screw Spacers (4)
F. 4mm Hex Key
G. 5mm Hex Key
H. Cap Screws (3)
I. Bracket Clamp Cover
J. Bracket Cover
K. Cable Cover
L. Warranty Certificate
M. General Safety Warnings
N. Installation Guide
You will also need
a Phillips-head
screwdriver
to secure your
monitors to the
bracket
Hey!
Let’s get your new monitor
bracket ready to use, fast!
Installation Guide
Model: AMAB-0221-S
Gas Spring Monitor Bracket
with USB ports
1
1
2
3
2
3
Be careful not to overtighten the clamp or you
might cause surface damage to your desk or table
Be careful not to overtighten the clamp or you
might cause surface damage to your desk or table
L
H
I
F
J
K
M
N
x 4
x 4
x 3
x 4
