38142-2-0719
Page 14
1
4
5
3
2
Before you begin: if you are installing logs into the BVD34
or BVD36 model, then this fireplace is supplied with a set of
five ceramic fiber logs. Do not handle these logs with your
bare hands! Always wear gloves to prevent skin irritation from
ceramic fibers. After handling logs, wash your hands gently
with soap and water to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean
operation of this fireplace. Sooting and other problems may
result if the logs are not properly and firmly positioned in
the fireplace. Please refer to
Figure 16
and
Figure 17
and
corresponding WARNING when completing following log
placement instructions.
1. Place front logs (#1 and #2) between front grate flange
and main burner. Align notches on front logs with locator
tabs in base.
2. Place middle log (#3) between front and rear loop of
burner.
Note: Do not place log on top of pilot assembly.
3. Place rear log (#4) on rear log shelf. Bottom flange of log
must be placed between the log shelf and burner tube.
4. Place branch (#5) onto (#1) log and flat area on (#3) log.
The bottom of the branch is to be placed behind the grate
tang that is second from the left.
5. Place decorative rock in front of grates and sides of main
burner pan.
ATTENTION
: Do not place decorative rock on logs or
burner. The decorative rock should only be placed on the
fireplace floor.
EmBER mATERIAL PLACEmENT ON BURNER
6. After all logs are positioned properly, apply Rockwool
ember material to the front burner port area. To apply,
carefully separate the ember material into small amounts
no larger than "dime size" pieces. Fluffed up pieces one
layer thick on top of the burner generally works best, and
will provide the best ember glow. Do not place ember
material more than one layer thick. No more than (1)
small packet of ember material (part no. 15999) evenly
placed on the burner, is recommended on BVD34 and
BVD36 models. Using additional ember material will
decrease the amount of ember glow effect. Extra ember
material should be saved for future ember applications
as necessary.
See Figure 17.
Figure 16
WARNING: Failure to position the parts in accordance
with this diagram or failure to use only parts
specifically approved with this appliance may result
in property damage or personal injury.
Attention:
Do not use
Figure 16
or
Figure 17
to order
logs. Refer to parts list on pages 32 and 34 and parts view
on pages 33 and 35 to order logs and/or ember material for
your appropriate fireplace model.
Figure 17
1
2
3
5
4
EMBER MATERIAL
PLACEMENT
LOG PLACEmENT (5 LOG SET)
Optional Platinum Bright Ember Kits are available from your
Fireplace Dealer. These embers may be used with all BVD/
BVP Series fireplaces. Order and use as indicated as below.
Platinum Bright Embers
PE-20-1
Note: A signle layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with
production embers) to the burner.
f i r e - p a r t s . c o m