Page 5
R-2688
Instructions to Installer
1.
Installer must leave instruction manual with owner after
installation.
2.
Installer must have owner fill out and mail warranty card
supplied with unvented room heater.
3.
Installer should show owner how to start and operate un-
vented room heater.
Always consult your local Building Department regarding regu-
lations, codes or ordinances which apply to the installation of an
unvented room heater.
This appliance may be installed in an aftermarket* permanently
located, manufactured (mobile) home, where not prohibited by
state or local codes.
*Aftermarket: Completion of sale, not for purpose of resale, from
the manufacturer.
This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other
gases.
General Information
This EE-25-2 is design certified in accordance with American
National Standard Z21.11.2b-1998 by the American Gas Associa-
tion Laboratories as an Unvented Room Heater and should be
installed according to these instructions.
Attention: During initial use of ceramic log you will detect an
odor as the ceramic log is cured. Also, during the curing
process the ceramic log will burn with a yellow flame.
Any alteration of the original design, installed other than as
shown in these instructions or use with a type of gas not shown
on the rating plate is the responsibility of the person and
company making the change.
Important
All correspondence should refer to complete Model No., Serial
No. and type of gas.
Notice: During initial firing of this unit, its paint will bake out, and
smoke will occur. To prevent triggering of smoke alarms, ventilate
the room in which the unit is installed.
Qualified Installing Agency
Installation and replacement of gas piping, gas utilization equip-
ment or accessories and repair and servicing of equipment shall be
performed only by a qualified agency. The term "qualified agency"
means any individual, firm, corporation or company which either
in person or through a representative is engaged in and is respon-
sible for (a) the installation or replacement of gas piping or (b) the
connection, installation, repair or servicing of equipment, who is
experienced in such work, familiar with all precautions required
and has complied with all the requirements of the authority having
jurisdiction.
The installation must conform with local codes or, in the absence
of local codes, with the National Fuel Gas Code, ANSI Z223.1.*
*Available from the American National Standards Institute, Inc., 11 West 42nd St.,
New York, N.Y. 10036.
Well Head Gas Installations
Some natural gas utilities use "well head" gas. This may affect the
Btu output of the unit. Contact the gas company for the heating
value. Contact the manufacturer or your gas company before
changing spud/orifice size.
High Altitudes
For altitudes/elevations above 2,000 feet (610m), ratings should
be reduced at the rate of 4 percent for each 1,000 feet (305m)
above sea level. Contact the manufacturer or your gas company
before changing spud/orifice size.
Accessories
Blower
EEB-1
Oak Mantel with Base
EEM-O
Mahogany Mantel with Base
EEM-M
Corner Mahogany Mantel
EEM-CM
Corner Oak Mantel
EEM-CO
Floor Stand
EES-25
Model
EE-25-2
Input BTU/HR (KW/H) Max.
25,000 ( 7.3)
BTU/HR (KW/H) Min.
14,000 (4.1)
Height
25 15/32" ( 647mm)
Width
21 1/8" (537mm)
Depth
6 3/8" (162mm)
Gas Inlet
3/8" (10mm)
INTRODUCTION
SPECIFICATIONS
Содержание EE-25-2
Страница 14: ...Page 14 R 2688 PARTS VIEW...
