38102-4-0319
Page 19
INSTALLATION (CONT’D)
18. Remove barrier screen assembly by lifting the screen
assembly and pulling it toward you.
see Figure 16.
caUtion
Do not handle barrier screen or door assembly with your
bare hands! (alWaYs Wear Gloves)
Figure 16
19. Remove glass door assembly: Using the glass door latch
tool provided, hook onto the latches on the top of the insert
and pry it over the glass door assembly flanges. The top of
the glass door assembly will angle toward you. Simply lift to
remove the glass door assembly.
see Figure 17.
Figure 17
20.
sync remote.
Push the sync button to the right of the insert.
see Figure 18.
With the batteries already installed in the transmitter, push the
ON button. The receiver will “beep” four times to indicate the
transmitter’s command is accepted and sets to the particular
code of that transmitter. The system is now initialized.
Figure 18
•
Install liners, logs, and rock wool. See liner and log set
instructions for the proper placement. Placement of the
glowing embers is for a glowing effect based on the look
you desire. Embers look best when placed in layers. Do
not place glowing embers around the pilot assembly.
Place pebbles across the front. Avoid blocking the large
rectangular holes.
SYNC
BUTTON
