Emotiva Airmotiv RS13, Руководство пользователя

Страница: 17 / 24

Page 13
AIRMOTIV RS13 R
efeRence
S
ubwOOfeR
4. Status LED
The Status LED on the Airmotiv RS13 provides information about the status of the RS13.
• An UNLIT Status LED indicates that the main AC Power switch is Off or there is no AC power.
• A RED Status LED indicates that the RS13 is in Standby mode.
• A FLASHING BLUE Status LED indicates that the RS13 is On but has not detected an input
signal.
• A BLUE Status LED indicates that the RS13 is On and playing or ready to play.
Note: When the RS13 is powering On, the status LED will blink several times before turning
solid RED to indicate that the RS13 is in Standby. This is part of the normal startup process.
Note: When the RS13 powers Off, you will notice that the Status LED and panel lighting flash
for a period, go off entirely, flash briefly a few seconds later, then flash briefly again after a few
more seconds. This is part of the normal shutdown process. The RS13 is only fully Off after the
second brief flash.
5. X-Over Switch
This switch enables you to bypass the internal crossover in the RS13. This switch should be set
to Out when the RS13 is connected to the Subwoofer or LFE output on a system that has bass
management, and should be set to In, to enable you to use the internal crossover on the RS13,
when the RS13 is connected to a full range output.
6. EQ Switch
This switch allows you to select between the Deep and Flat response curves on the RS13.
The Deep response curve is the flattest, with a response flat /-3dB to 16 Hz.
The Flat setting introduces a slight rolloff at very low frequencies.
The rolloff starts at about 30 Hz and results in a response that is -3 dB at 21 Hz.
Limiting the lowest frequencies results in a slightly higher maximum output.
7. Power Auto/On Switch
This switch selects between allowing the RS13 to remain powered on at all times and enabling
the RS13 to automatically turn on when it detects an audio signal.