emmeti 07239715, Инструкция по установке и эксплуатации

Страница: 29 / 54

29
1. TITOLO 2. USE OF HEAT PUMP
GB GB
This unit is designed for production of sanitary water
in households and at premises
where daily consumption of hot water (40 °C) does
not exceed 150 l to 250 l. The appliance must be
connected to water supply mains and to the power
supply grid. The air intake and air exhaust may also be
provided by designing the inlet and outlet drain from
and to the adjacent room.
In case of installing the unit in a room with a bathtub
or shower tub, take into account the requirements
defined in the IEC 60364-7-701 standard (VDE 0100,
Teil 701). To mount the unit on the wall, use special
wall bolts with a nominal diameter of minimum 8
mm and always mount the unit in an upright posi-
tion. Make sure the mounting location on the wall is
adequately reinforced if the wall is not strong enough
(unit weight whit the water). We recommend leaving
enough space between the floor and unit as to pro-
vide easy access to the Mg anode (for maintenance
or replacement purposes – Fig. 4). If not, the unit will
need to be dismounted from the wall before servi-
cing.
The heat pump may not be used for purposes other
than those defined in these Instructions. The unit is
not designed for industrial use or use in rooms where
corrosive or explosive substances are present.
The manufacturer shall not assume any liability for
damages caused by incorrect
installation or misuse that are not in compliance with
the Instructions for installation and use.
The instructions for use are a component and im-
portant part of this product and must be delivered to
the customer. Read the warnings carefully, as they
contain important directions related to safety during
operation, use and maintenance.
Keep these Instructions for later use.
The marking of the heat pump is stated on the name-
plate located on the bottom side of the unit, between
both inlet pipes for sanitary water.
Once the packaging is removed, check the contents.
When in doubt, contact your dealer. Never let children
play with the packaging parts (clamping, plastic bags,
expanded polystyrol, etc.) – potential risk. Make sure
to remove and dispose of the packaging safely and in
an environmentally friendly way.
STORAGE AND TRANSPORT
Store the heat pump in an upright position, in a clean
and dry place.