EMIT ETS1, Инструкция по эксплуатации

Страница: 18 / 25

ETS1 ver. 1.22
Tid nr Indicates which of the split times that is shown.
Brikketid The tag’s internal time measured from when the tag’s clock was started.
This square is red when the time deviates from the calculated time by
more than the number of seconds you have allowed. The times will
always differ some if you don’t use a starting station.
Innk.tid The time when the ETS1 read the tag.
Error messages:

Common errors are displayed in green.

Start number 4 is registered as quitted or disqualified. If this tag passes the
finishing line, you will get an error report.

The tag passing the finishing line after number 4 is unknown. No
competitor in the data base is registered with this tag number.

Start number 2 finishes the competition for the second time. The time will
not be adjusted, but is reported as an error.

Start number 5 crosses the finishing line before he has started. The time will
not be registered.
The status field:

‘Status’ indicates if there is communication with the tag reader.

’Tider/Oppdaterte’ logs the number of times updated in the data base.

’Sist lest’ shows when the last tag was read.

’Feil’ shows the number of errors during the timing.

’Ukjente løpere’ shows the number of read unregistered tags.
For sprint there is a special field for the starting time, which is the same for all the
competitors in the same heat.
CORRECTING ERRORS
The tags are registered in the ETS1, but nothing is transferred to the
eTiming:

Check that the cable between the ETS1 and the PC is conncted to the correct
port.

Check if the ’Sist lest’(’Last read) field is being updated. If it does, the
competitor probably hasn’t started yet.

Go to the ’Oppsett’ (Setup) tab and turn on ’Advarsel dersom tid før start’
(warning when times occur before start) and ’Vis men ikke overskriv
måltider’ (Show, but do not adjust finishing times).

Check that ’Seriell kommunikasjon’ (Serial communication) is chosen as
form for contact (the tab ‘Emit Elite’) when you use a serial cable or a serial
USB converter.

USB: If you are warned of communication errors when you start the timing,
the reason often is that the USB port is busy or not ready for use. Try
another USB port and reconnect.
Page
18