USER INTERFACE
The display of the ETS2 has seven available lines and up to 20 symbols. Three
keys on each side of the display control the various menu choices. In addition the
keypad has numerical keys and comma, plus four set keys.
'Menu'
- in or out of menu modus
'Clear'
- deletes the last symbol or leaves the menu
'On/Off'
– turns on or off the ETS2 (hold for five sec. to turn off)
'Enter'
- accepts choices
Operation mode
Start the ETS2 by pressing the '
On/Off
' key. Two seconds later you will see
version number, battery status, radio status and clock. You will also hear clicking
sounds from the unit – this is the eLine loops’ drivers, which are automatically
adjusted every time the ETS2 is turned on. When the start-up procedures are
done (ca. 5 sec.) the display will show what time it is (HH:MM:SS), how many
tags that are registered (M=0) and to which code the ETS2 is set (C=100). If a
4G modem is connected (and enabled) the display will show '4G'next to M=0.
If an external eLine loop is not connected, you will be asked the following
question:
Answer ’'Off' if you don't want to use a loop with the ETS2. Choose 'Internal’ if
you want to use the internal eLine loop. Note that this loop is mounted at the
bottom of ETS2, and the range is merely three meters. Answer ‘External’ if you
have connected an external eLine loop to the '
LOOP 1
' port on the ETS2.
Check that the LEDs for loop1 og loop2 have the correct colour (see page six for
details) and that all cables are properly connected.
The ETS2 is now in operation mode and is ready for use.
