10 |
ENGLISH
5.0 Manual configuration as an Access Point
Install the wLINK 300 as an access point if you have a router or DSL modem router.
Make sure that your Internet browser and your network are well configured when
configuring manually. You can assume that the settings are correct, unless you have
changed any of the settings in the past.
Example of wLINK 300 as an Access Point
5.1 Connecting the wLINK 300
1.
Turn off the computer.
2.
Connect the wLINK 300 to a wall outlet using the supplied power adapter.
3.
Connect the supplied UTP network cable to the ‘LAN 4’ port of the wLINK 300.
4.
Connect the other end of this UTP network cable to the network adapter of your
computer.
Is my wLINK 300 correctly connected to the wall outlet? You can check this by
verifying that the POWER LED is on.
Do I have a proper network connection? Turn on the computer and verify if the LED on
the wLINK 300, corresponding with the LAN-port to which you connected the UTP
networking cable, is lit. The LED on the network adapter of your computer should also
be lit..
5.2 Configuring the wLINK 300 as an Access Point
Before you can configure the wLINK 300 for an Internet connection you first need to
connect to the wLINK 300 by following the procedure below.