4
PN 20009722 REV F, [08/01/2020]
IMPORTANT SAFETY INFORMATION
Become Familiar With Symbols
Become Familiar With Symbols
Identifying Potential Hazards.
Identifying Potential Hazards.
All field wiring shall conform to requirements of authority
having jurisdiction or in absence of such requirements:
• United States - National Electrical Code, ANSI/NFPA 70.
Unit must be electrically grounded in conformance to
this code.
• Canada - CSA C22.1 Canadian Electrical Code Part 1.
DANGER
Indicates a hazardous situation which, if not
avoided, WILL result in death or serious injury.
!
WARNING
Indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
!
CAUTION
Indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
!
!
NOTICE
Indicates information which should be followed to
ensure proper installation and operation.
WARNING
Electrical shock hazard. Improper assembly and/or
installation could result in death or serious injury.
Have a qualified service agency install and service
this appliance. Read this manual and understand all
requirements before beginning installation.
!
Safety Information
•
Have a qualified service agency install and service this
appliance.
•
Turn off electrical supply before servicing unit.
•
Do not have other devices such as fire alarm circuits,
BMS circuits, etc on same circuit as the unit.
• Inspect all parts for damage prior to installation and
start-up.
• Do not use unit if it has damaged wiring, is not working
properly, or has been damaged or dropped.
• Connect to properly grounded electrical supply with
proper voltage as stated on rating plate.
• Use proper over-current protection (i.e. time-delay
fuse/HACR Breaker) as listed on Rating Plate.
• Service or repair of unit using manufacturer approved
replacement parts only.
• Do not use any mechanical or electrical controllers
which have been wet. Replace any defective controller.
• Do not support any part of ceiling with appliance,
associated wiring or pipe work.
• Check rating plate on unit before installation. Verify
voltage shown is same as electric supply to unit. Rating
plate is located on top panel.
WARNING
Tampering with this unit is dangerous and could
result in death or serious injury. Do not modify or
change this unit.
!
