42
MODEL 5081-A
SECTION 7.0
PROGRAMMING
SECTION 7.0
PROGRAMMING
7.1
General
7.2
Default Settings
7.3
Temperature Settings
7.4
Display
7.5
Calibration Setup
7.6
Line Frequency
7.7 pH Measurement
7.8
Barometric Pressure
7.1 GENERAL
this section describes how to do the following:
1. enable and disable automatic temperature correction
2. program the type measurement (oxygen, ozone, or chlorine)
3. setup stabilization criteria for calibration
4. enable automatic pH correction for chlorine measurements
5. choose units for barometric pressure (oxygen only)
6. choose limits for diagnostic fault messages
Each section contains definitions of terms used, programming instructions using the infrared remote controller, and pro-
gramming instructions using deltaV.
7.2 DEFAULT SETTINGS
table 7-1 lists the default settings for the 5081-A transmitter. the transmitter is configured at the factory to measure
oxygen.
IMPORTANT
Before changing any default settings, configure the transmitter for the measurement you want to
make: oxygen, free chlorine, total chlorine, or ozone. Changing the measurement ALWAyS returns
the transmitter to factory default settings.