Emerson Rosemount 326L, Быстрый старт

Страница: 37 / 52

Set to another medium
If the medium in the tank has changed, modify the parameters for the medium to match
the new medium.
Procedure
1. Select MEdI from the menu.
2. Set the medium type.
• HIGH : For water and water-based media.
Operating mode is optimized for suppression of deposits on the probe.
•
MId
: For water-based media and media with a medium dielectric constant value
(oil-in-water emulsions).
Operating mode optimized for the detection of media with increased foam
build-up.
3. Press
Enter
.
Note
In case of doubt, perform an application test to ensure that the setting is best suited
for the medium.
3.4.7 Simulation
Simulation mode allows you to perform tests on the level transmitter while it simulates
levels and error scenarios.
Set simulation value
The simulation value determines what error scenario the simulation shows.
Procedure
1. Select
S.LvL
from the menu.
2. Set the simulation value:
• Numerical value : level in millimeters or inches (depending on the basic setting)
•
FULL
: full state
• SEnS : weak measured signal
• Err : electronic fault found
•
EPTY
: empty state
3. Press Enter .
Quick Start Guide Operation
00825-0100-4326 January 2019
Quick Start Guide 37