5. Obtain the die cast glass holders and light kit glass
from the protective bag.
6. Position light kit glass carefully on a convenient
surface with the open side face down.
7. Remove the protective cover from the adhesive
backed material on the glass holders (Figure 35).
8. Firmly press the die cast glass holders into position
on the light kit glass (Figure 36).
9.
Repeat these procedures for the second die cast
holder.
10. Carefully turn the light kit glass assembly over
and thread the two screws (supplied) into the die
cast glass holder. Leave approximately 3/16” of
the thread revealed (Figure 37).
11. Raise the light kit glass assembly and insert the
two screws in the two keyholes in the light kit
adapter. Turn the light kit glass assembly
counterclockwise to engage the screws in the
slots; tighten the screws using a 6-inch blade
screwdriver or a 90-degree angled
screwdriver (Figure 38).
DIE CAST
GLASS HOLDER
PROTECTIVE
COVER ON
ADHESIVE
BACKED
MATERIAL
Figure 35
DIE CAST
GLASS HOLDER
LIGHT KIT
GLASS
Figure 36
INSERT SCREW (SUPPLIED)
WITH APPROXIMATELY 3/16"
GAP BETWEEN SCREW HEAD
AND DIE CAST GLASS
HOLDER
DIE CAST
GLASS HOLDER
LIGHT KIT GLASS
ASSEMBLY
Figure 37
BLACK
BLACK FAN WIRE
LISTED OUTLET BOX
LIGHT
CONTROL
GREEN WIRE
(GROUND)
FROM
HANGER
BRACKET
TO 120
VOLT
SUPPLY
WHITE
WHITE
GROUND
GROUND
GREEN WIRE (GROUND)
FROM HANGER BALL
LISTED WIRE
CONNECTOR (4)
GROUND
WIRE
WHT.
RED
BLACK
EMERSON
FAN
CONTROL
BLACK
(HOT)
YELLOW
BLUE
RED
FINAL ASSEMBLY
1. Screw the two 1-1/4” threaded studs (supplied) into
the tapped holes in the hanger bracket.
2. Lift the ceiling cover up to the threaded studs and
turn until studs protrude through the holes in the
ceiling cover (Figure 34).
3. Secure the ceiling cover in place by installing two
lockwashers and two knurled knobs (supplied)
(Figure 34). Tighten the knurled knobs securely
until the ceiling cover fits snugly against the ceiling
and the hole in the ceiling cover is clear of the
downrod.
4. Screw in three 40-watt (maximum) candelabra
base lamps in the uplight assembly sockets and
three 60-watt (maximum) candelabra base lamps in
the light kit plate sockets for the lower light.
12
1-1/4"
THREADED
STUD
CEILING COVER
KNURLED KNOB
LOCKWASHER
Figure 34
Figure 33
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box
and not pinched between the ceiling cover and the
ceiling.
WARNING
!
