Emerson Micro Motion 1600, Руководство по установке

Страница: 29 / 48

6 Set up the printer
Use this section to set up printing with a 1600 Ethernet transmitter and an
Epson TM-T88VI Ethernet printer. For information on configuring the printer, see
Micro
Motion 1600 Transmitters with Configurable Inputs and Outputs: Configuration and Use
Manual
.
There are two ways to set up printing:
• Use the printer's default IP address
• Change the printer's default IP address
6.1 Set up the printer by changing the printer
default IP address
Use this procedure to set up printing with a 1600 Ethernet transmitter and an Epson TM-
T88VI printer by changing the printer's default IP address.
Procedure
1. Connect one end of an Ethernet cable and power supply to the printer.
2. Connect the other end of the Ethernet cable to the PC.
3. Power on the printer.
The printer IP address prints after a few minutes.
4. Temporarily change the Ethernet address for the PC so that the Ethernet is on the
same subnet as the printer:
Default IP address = 192.168.192.168
a) From Windows 10, right-click the Start button and select Network
Connections .
b) Right-click the Ethernet connection and select Properties .
Select
Yes
on any user account pop-up windows.
c) Select Internet Protocol Version 4(TCP/IPv4) , then select properties .
d) Select Use the following IP address and configure the IP address and subnet
mask as follows:
• IP address: 192.168.192. x , where x is something other than 0, 1, or 168
• Subnet mask: 255.255.255.0
e) Select OK .
5. Change the printer firmware options.
a) Open your web browser and type
http://192.168.192.168
(default
printer IP).
The browser displays,
Your connection is not private
. Ignore the
warning and proceed to the website.
Installation Manual Set up the printer
00825-0100-1600 March 2022
Installation Manual 29