Emerson Lumity IC100D EVO, Краткое руководство пользователя

Страница: 11 / 40

1592022020 iCHILL 100D EVO QRG EN rel. 2.0 23.02.2022 11/40
6.2 MODIFY THE SET POINT
•
push SET key for at least 3 seconds
•
use the UP or DOWN key to modify the setpoint. In chiller mode it is possible to modify the chiller
set point, in heat pump it is possible to modify the heat pump set point, in std-by it is possible to
modify both the set point.
•
push SET to confirm or wait the timeout (15seconds).
7 KEY FUNCTION
KEY ACTION FUNCTION
Push and release
Show chiller set point SetC, heat pump set point
SetH, sanitay water set point SetS
Push once again
In chiller or heat pump if the Energy saving or the
Dynamic setpoint are enabled it shows the real
setpoint Setr.
Push for 3 seconds Allows to modify the set point
During the programming: push
once
To enter parameter modification or confirm a value
Push when an alarm is showed in
menù ALrM
To reset the alarm
Push once To read probes value
Pushing once during the
programming
To change the group of parameters, to change the
parameter, to change the value of the parameter
Push for 1 second during the
programming when the display
visualizes Pr1 or Pr2 or Pr3
1 time shows the Pr2 programming level
2 times shows the Pr3 programming level
Push once To read probes value
Pushing once during the
programming
To change the group of parameters, to change the
parameter, to change the value of the parameter
Push once
To turn ON or turn OFF the controller (in chiller or
heat pump depending from CF59 parameter)
Push once
To turn ON or turn OFF the controller (in chiller or
heat pump depending from CF59 parameter)
Push once To enter the function Menu
Push for 3 seconds
To set the clock (only for controller with clock on
board)