Emerson GEO10, Справочное руководство

Страница: 8 / 147

Reference Manual
Rev 1.0
August 2020
8 Emerson.com
equipment can be dangerous and could result in injury. Properly dispose of damaged Anchor
batteries or Tags immediately.
The Emerson Location Anchor shall be used only with the battery (00G45-9000-0001) supplied
by Rosemount. This battery has been officially tested with the Location Anchor as required by
the I.S. standards during the assessment of the Emerson Location Anchor.
The battery is not replaceable in a hazardous location.
Dispose of battery in accordance with local and national requirements.
Do not place the Location Awareness Anchor, Anchor battery or the Location Awareness Tag
device near fire or heat to reduce the risk of explosion and possible injury.
Shipping considerations
The Anchor unit was shipped with the battery installed. Each Location Anchor contains one “D”
size primary lithium battery. Primary lithium batteries are regulated in transportation by the U. S.
Department of Transportation and are also covered by the International Air Transport
Association (IATA), International Civil Aviation Organization (CAO), and European Ground
Transportation of Dangerous Goods (ARD). It is the shipper’s responsibility to ensure
compliance with these or any other local requirements. Consult current regulations and
requirements before shipping.
This Location Anchor complies with Part 15 of the FCC Rules. Operation is subject to the
following conditions: The Anchor may not cause harmful interference. The Anchor must accept
any interference received, including interference that may cause undesired operation. The
Anchor, Model GEO20, must be installed to ensure a minimum antenna separation distance of
20 cm (8 in.) from all persons.
Section 4: Location Anchor Configuration
4.1 Location Anchor Configuration
Remove the Location Anchor electronics cover and connect to the HART® Communication
terminals for configuration.
The Emerson Location Anchor will receive HART Communication from any HART handheld
Field Communicator or AMS™ Device Manager.
AMS Device Manager
AMS Device Manager can connect to devices directly, using a HART modem, or remotely using
the Gateway. To configure the Emerson Location Anchor, double click (or right click and select
Configure/Setup) on the device icon that will appear below either the HART modem or Gateway
connection tree.
4.2 Device Network Configuration
Notice