Emerson GEO10, Справочное руководство

Страница: 20 / 147

Reference Manual
Rev 1.0
August 2020
20 Emerson.com
indicated by a warning symbol ( ). Refer to the following safety messages before performing
an operation preceded by this symbol.
Location Awareness Tags and Anchors use lithium batteries and are subject to local, state,
national, and/or international requirements. Lithium batteries may ignite, explode or release
toxic and harmful materials or chemicals if mishandled. Do not use a battery that is damaged.
Do not incinerate batteries. Do not crush, disassemble, heat batteries above 100°C (212°F) or
expose contents to water. Please check and comply with all applicable local, state, national,
and international regulations before transporting, disposing or recycling lithium batteries. Do not
recharge Anchor battery. Do not use Anchor battery that has been dropped. Use of damaged
equipment can be dangerous and could result in injury. Properly dispose of damaged Anchor
batteries or Tags immediately.
The Location Awareness Personnel Tag is equipped with a permanently installed, lithium-ion
rechargeable battery. Do not disassemble Personnel Tag or attempt to replace the battery. Do
not store Personnel Tag in areas where there is excessive heat or cold (e.g. inside vehicles).
Recharge Location Awareness Personnel Tag only with Qi certified wireless chargers in a non-
hazardous area. Charger must be approved as SELV or Class 2 equipment against CSA/UL
60950, CSA/UL 61010-1 or equivalent ordinary location standard. The maximum voltage from
the charger must not exceed 30 VDC. Adhere to all Qi charger manufacturer guidelines and
recommendations.
Do not charge the Personnel Tag in a damp or wet location to reduce the risk of electric shock.
The Personnel Tag should only be charged when the Tag is at room temperature. If the
Personnel Tag has been in a cold environment, make sure to allow it to warm to room
temperature before charging.
Do not place the Location Awareness Anchor, Anchor battery or the Location Awareness Tag
device near fire or heat to reduce the risk of explosion and possible injury.
If wearing the Tag with a lanyard, it must be a breakaway lanyard worn properly.
Section 10: Personnel Tag Commissioning and
Configuration
Power Up Sequence
1. Charge Personnel Tag for approximately three hours using a certified Qi Charger.
2. To remove Personnel Tag from shipping mode, press and hold safety button until LED is
solid green. This should take approximately three seconds.
3. Once you release the safety button, the Personnel Tag LED will follow the status shown
in Table 12.1.
Commissioning and Configuration
Follow steps outlined in Section 13 for Personnel Tag commissioning and configuration.
WARNING