3. Tighten the two setscrews (Figure 2) securely while
pulling up on the downrod.
NOTE: The setscrews must be properly installed
as described above, or fan wobble could result.
4. Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure that
the ceiling cover and the coupling cover are both
oriented correctly (Figure 3).
5. Reinstall the hanger ball (Figure 4) on the downrod as
follows. Route the three 80” motor leads through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball.
A loose setscrew could create fan wobble.
4
DOWNROD
COUPLING
COVER
CEILING
COVER
Figure 3
HAIRPIN
CLIP
DOWNROD
CLEVIS
PIN
MOTOR
COUPLING
SETSCREW (2)
Figure 2
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 4
CAPTIVE PHILLIPS
FLANGE SCREW
M5 x 6mm SLOTTED
PHILLIPS WASHER HEAD
SCREWS (3)
RIB LINE
(THIS SIDE UP)
FAN BLADE
BLADE FLANGE
Figure 5
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed (as shown in Figure 2) could
result in the fan falling.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are proper-
ly installed could result in the fan falling.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
WARNING
!
6. The fan comes with blue, black and white leads
that are 80-inches long. Before installing the fan,
measure up approximately 6 to 9-inches above top
of hanger ball/downrod assembly. Cut off excess
leads and strip back insulation 1/2-inch from end of
leads.
7. Mount blade flanges to fan blades using three
M5 x 6mm slotted Phillips washer head screws
(Figure 5).
IMPORTANT: THE SIDE OF THE FAN BLADE
HAVING THE RIB LINE MUST BE FACING
UPWARDS AS SHOWN IN FIGURE 5.
8. Turn the fan motor assembly upside down in
preparation for mounting the fan blade assemblies.
Remove and discard five shipping retainers
securing the motor in the motor housing.
NOTE: Take care not to scratch fan housing when
installing blades.
U.L. Model No.: 51-OD
