13.
Slide the rod support assembly up
the downrod until the threaded holes in
the rod support align with the
holes in the decorative rod assemblies
(Figure 12). Secure the decorative
rods to the rod support using three
decorative rod screws; do not tighten
the rod screws at this time.
14.
Rotate the rod support assembly until
the decorative rod assemblies are
aligned vertically with the downrod
(Figure 12). Hold the rod support in
this position while tightening all six
decorative rod screws securely.
DECORATIVE ROD
ASSEMBLY
DECORATIVE
ROD SCREW
Figure 11
7
U.L. Model No.: CF205
11.
Make sure the grommets are properly
installed in the rod support assembly.
Then position the three screws in the
rod support toward the top, and slide
the rod support over the downrod
(Figure 10).
ROD SUPPORT
ASSEMBLY
MOTOR
HOUSING
GROMMET
COUPLING
COVER
SCREWS (3)
(Toward Top)
Figure 10
12.
Using the decorative rod screws (sup-
plied), attach the three decorative rod
assemblies to the motor housing
(Figure 11). The decorative rods must
be oriented so that they lean in
towards the downrod. Do not tighten
the rod screws at this time.
It is critical that the pin in the hanger
ball is properly installed and the
setscrew securely tightened. Failure
to verify that the pin and setscrew
are properly installed could result in
the fan falling.
!
WARNING
DECORATIVE
ROD
ASSEMBLY
DECORATIVE
ROD SCREW
DOWNROD
ROD
SUPPORT
ASSEMBLY
Figure 12
BP7375-1 Highpointe 8/19/10 2:50 PM Page 7
