13
U.L. Model No.: CF205
LIGHT KIT
PLATE
LIGHT KIT
COVER PLATE
FLAT AREA
LIGHT KIT PLATE
SOCKETS REMOVED
Figure 24
5.
Place the cover plate onto the fan
motor/housing aligning the three flat
areas on the top flange of the cover
plate with the three pins on the inside of
the fan motor/housing (Figure 24).
Then turn the cover plate clockwise
until it stops turning.
6.
Your cover plate is now installed.
To avoid possible fire or shock, make
sure that the electrical wires are com-
pletely tucked inside the lower assembly
and not pinched by the cover plate.
!
WARNING
4.
Carefully tuck blue and white wires
from motor up into the fan motor/hous-
ing assembly (Figure 24).
Remote Control
Procedures
General
Your Emerson Ceiling Fan/Light Remote
Control consists of hand-held transmitter
and a receiver which is mounted under the
fan ceiling cover. The remote control is
designed to separately control your ceiling
fan speed and light intensity. There are
four push buttons (
.
,
..
,
...
,
....
) to set the
fan speed and turn the fan off. The light
( ) push button turns the light on and off
and controls the light intensity. The blue
indicator light will illuminate while any but-
ton is pressed, indicating that the battery is
good.
The remote control transmitter is powered
by two AAA alkaline batteries (not includ-
ed). To prevent possible damage if the bat-
teries should leak, be sure to remove the
batteries when the control is not to be
used for an extended period of time.
Code switches in the transmitter may be
set in 32 different positions. If your fan and
light go on and off without using your con-
trol, you may be getting interference from
other remote units such as garage door
openers, car alarms or security systems.
To remedy this situations, simply change
the combination code in your transmitter.
Preset Memory Feature
Your Emerson receiver is equipped with a
preset memory feature. If the AC supply to
the receiver is powered through a wall
switch, when the switch is turned OFF, the
control will remember the light intensity
and fan speed. When the switch is turned
back ON the light and fan will resume
operation as they we re prior to the switch
being turned OFF.
Figure 25
Installation of Battery
1.
Remove the battery cover by pressing
firmly below the arrow and sliding the
cover off the control (Figure 25).
2.
Remove the connector from the battery
compartment and install two AAA alka-
line batteries.
CODE
SWITCHES
SR400 REMOTE
CONTROL
BATTERY
COMPARTMENT
COVER
TWO AAA
BATTERIES
REMOTE CONTROL
LEVERS
ON
1
2
3
4 5
I
BP7375-1 Highpointe 8/19/10 2:50 PM Page 13
