4.
Connect the white wire from the light kit
plate to the white wire in the fan motor/
housing assembly (Figure 6). Connect
the black wire from the light kit plate to
the black wire in the fan motor/housing
assembly.
1/4-20 x 11mm PAN HEAD
SCREW (2 per flange)
BLADE
FLANGE
MOTOR
HUB
Figure 5
LIGHT KIT
PLATE
BLACK WIRE
BLUE WIRE
FAN MOTOR/
HOUSING
ASSEMBLY
WHITE WIRES
Figure 6
U.L. Model No.: CF205
2.
Remove and discard the three shipping
retainers securing the motor hub in the
motor housing.
NOTE: Take care not to scratch the fan
housing when installing the blade
assemblies.
3.
Rotate the motor hub to position the
slot in the motor plate over a fan motor/
housing flange hole. Attach the blade
flange assembly on the fan motor/
housing by slowly rotating the motor
hub to align screw holes. Tighten the
screws securely while interlocking the
flange assemblies as you rotate the
hub (Figure 5).
Your ceiling fan can be assembled with
the light kit and glass or without the
light kit and glass. To assemble without
the light kit and glass, you will use the
no-light cover plate. In order to use the
no-light cover plate, the light sockets
will need to be removed from the light
kit plate.
CAUTION: Before installing and tight-
ening the screws, be sure there are no
wires pinched between the light kit
plate and the fan motor/housing
assembly.
NOTE: In order to remove the light
sockets, the wires on the light kit plate
will need to be cut. MAKE SURE THIS IS
THE NO LIGHT ASSEMBLY DESIRED.
NOTE: If no light kit is to be used on the
ceiling fan, disregard Steps 4 and 5;
proceed to “How to Disassemble Your
Light Kit for Cover Plate Assembly
Only”, then continue to Step 6.
5
5.
Remove one of the fan motor/housing
assembly screw (retain for later use).
Position the light kit plate on the fan
motor/housing assembly aligning the
keyhole slots over the fan motor
screws. Rotate the light kit plate clock-
wise to engage the screws into the key-
hole slots. Reinstall the previous
removed screw. Tighten the three
screws to secure the light kit plate to
the fan motor/housing (Figure 7).
LIGHT KIT
PLATE
MOTOR
SCREW (3)
Figure 7
BP7375-1 Highpointe 8/19/10 2:50 PM Page 5
