Emerson Bristol ControlWave Express, Инструкция по эксплуатации

Страница: 55 / 88

ControlWave Express Instruction Manual (CI-ControlWave Express)
Chapter 4 – Operation
This chapter provides general operational details for using the
ControlWave Express.
In This Chapter
4.1 ................4-1 Powering Up/Powering Down the ControlWave Express
4.2 ..............................4-2 Communicating with the ControlWave Express
4.2.1
.................................................4-2 Default Comm Port Settings
4.2.2 ...................4-2 Collecting Data from the ControlWave Express
4.3 ..4-3 Creating and Downloading an Application (ControlWave Project)
4.4 ..................................................4-3 Creating and Maintaining Backups
4.4.1
............4-4 Creating a Zipped Project File (*.ZWT) For Backup
4.4.2 .................4-5 Saving Flash Configuration Parameters (*.FCP)
4.4.3 ...................................................................4-6 Backing up Data
WARNING
EXPLOSION HAZARD
Substitution of components may impair suitability for use in Class I,
Division 2 environments.
When the ControlWave Express is situated in a hazardous location,
turn off power before servicing or replacing the unit and before
installing or removing I/O wiring.
Do not disconnect equipment unless the power is switched off or the
area is known to be non-hazardous.
4.1 Powering Up/Powering Down the ControlWave Express
The ControlWave Express receives power either from a solar panel and
user-supplied battery or from an external bulk power supply attached
using connector TB1 on the CPU/System Controller board. It can also
receive power through alternate connector TB2 on the same board.
Chapter 2 includes instructions for wiring power to the ControlWave
Express. See Figure 2-3 for the location of these connectors.
Power Up To apply power to the ControlWave Express, plug in connectors TB1
and optionally TB2 on the CPU/System Controller board. If your
ControlWave project resides in flash memory, the project will load into
SRAM and begin execution. Depending upon the setting of the SRAM
control switch, retain variable values may load as well.
Caution
When you disconnect power from the ControlWave Express, your
running control strategy is erased from SRAM, as is any process data
not stored in retention mode. When configured for retention and the
backup battery remains good, SRAM stores the last states of all I/O
points, audit/archive data not residing in FLASH, the values of all
variables marked RETAIN, the values of variables stored in the static
memory area, and any pending unreported alarm messages.
Revised Mar-2011 Operation 4-1