emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF921
3. Ceiling Fan Assembly
5
UPPER
SETSCREW
DOWNROD
HAIRPIN
CLIP
MOTOR
COUPLING
SETSCREW
CLEVIS PIN
CLEVIS
PIN
HAIRPIN
CLIP
CLEVIS PIN
Figure 2
DOWNROD
PIN
SETSCREW
HANGER BALL
Figure 1
1.
Remove the hanger ball by loosening the setscrew in
the hanger ball until the ball falls freely down the
downrod (Figure 1). Remove the pin from the
downrod, then remove the hanger ball. Retain the pin
and hanger ball for reinstallation in Step 4.
2.
Separate, untwist and unkink the two 80” motor
leads. Route the motor lead wires through the
downrod. Remove the upper setscrew from the motor
coupling. Align the clevis pin holes in the downrod
with the holes in the motor coupling. Install the clevis
pin and secure with the hairpin clip (Figure 2). The
clevis pin must go through the holes in the motor
coupling and the holes in the downrod. Be sure to
push the straight leg of the hairpin clip through the
hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis pin.
The hairpin clip must be properly installed to prevent
the clevis pin from working loose. Pull on the
downrod to make sure the clevis pin is properly
installed. Reinstall the upper setscrew in the motor
coupling. Check that the lower setscrew is tightened
securely (Figure 2).
NOTE: The setscrews must be properly installed as
described above, or fan wobble could result.
NOTE: If LKU100 is being assembled, see Page 12,
“Optional Accent Light Kit Installation” of
instruction procedures.
It is critical that the clevis pin in the motor coupling is
properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
WARNING
!