11
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF921
7. Programming the Receiver Operating Frequency
& High Speed Conditioning of Fan Control
IMPORTANT: Ceiling fan blades MUST be
installed before high speed conditioning can
begin.
1.
Within 1 minute of restoring electricity to the ceiling
fan, push and hold the fan OFF button ( ) for 3 to 5
seconds to set the code in the receiver. The ceiling
fan lights (if installed) will blink to indicate the
transmitted has been paired with the receiver.
IMPORTANT: Immediately after successful
pairing, the ceiling fan will automatically
begin high speed conditioning of the motor.
During conditioning, the electronic motor
control software is calculating speeds for the
2nd through 5th speed settings based on the
blades that were installed on the fan.
2.
The fan will run for approximately 2 minutes in the
upward direction then reverse direction to down flow
and run an additional 2 minutes. When conditioning
is complete, the fan will come to complete stop.
IMPORTANT:
Do not interrupt the
conditioning until the fan comes to a
complete stop in approximately 5 minutes.
All functions of the control will be rejected
during conditioning.
3.
High speed conditioning is now complete.
4.
If programming is unsuccessful, retry the above
instructions after cycling the wall control ON/OFF
switch to restart the 1 minute programming time
period.
5.
If still unsuccessful, shut off the electricity at the fuse
box or breaker panel and change the control
frequency (page 9). After changing the frequency
settings, repeat instruction #1 of this section within
one minute of restoring the electricity.
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal injury
or property damage.
WARNING
!
1.
Ceiling Fan Light Kits (see store or catalog).
2.
Ceiling Fan/Light Controls (see store or catalog).
3.
Downrod Extension Kits (see store or catalog).
4.
Ceiling Fan Blades (see store or catalog).
9. Accessories
The use of any other control not specifically approved
for this fan could result in fire, shock and personal
injury.
WARNING
!
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of an electrical shock.
WARNING
!
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the finish.
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
8. Maintenance