Connecting to the Service Terminal Interface
81
5. In the Connect To window, shown below, select the appropriate connection method from the
Connect Using drop-down list:
A.2.3 Set Up the COM1 Port - Direct Connection Only
The following steps apply only to setting up a direct connection to the Service Terminal Interface via
the AC8’s RS232 port. If you are setting up a remote connection via modem, skip to
Step 8
(next sec-
tion).
COM1 Port Setup
6. In the COM1 Properties window, shown below, make the following selections:
• Bits per second:
9600
• Data bits:
8
• Parity:
None
• Stop bits:
1
• Flow control:
None
7. Click
OK
. When the connection is open, the connection name appears in the title bar of the
HyperTerminal window. To complete the setup, continue with
Step 8
(next section).
Direct Connection via RS232
• To set up a direct connection via the
AC8’s RS232 port, select
COM1
as
shown above.
This opens the COM1 Properties
window.
• Proceed to
Step 6
(next section).
Remote Connection via Modem
• To make a remote connection through the AC8’s
modem, select your computer’s modem—
Standard
9600 bps Modem
in the example shown above.
• Enter the area code and phone number of the AC8’s
modem.
• Skip
Steps 6
and
7
and proceed to
Step 8
in
A.2.4 -
Set Up the Connection’s Properties
.
Choose
COM1
& proceed to Step 6
DIRECT CONNECTION
Choose the computer’s modem
& proceed to Step 8
REMOTE CONNECTION
Содержание Autochangeover Controllers AC8
Страница 1: ...SITE MONITORING AND SERVICES AC8 USER MANUAL ...
Страница 2: ......
Страница 8: ...vi ...
Страница 127: ......
